Disassembling an Xbox One controller could look like a frightening job, however it’s a comparatively simple course of that may be accomplished with the best instruments and somewhat endurance. Whether or not you are experiencing controller points that require troubleshooting or just need to give your controller a deep clear, disassembling it may be a useful step. Nonetheless, earlier than you begin, it is essential to assemble the required instruments and take precautions to keep away from damaging the controller. By following the steps outlined on this information, you’ll be able to safely disassemble your Xbox One controller with ease.
To start, you’ll need a set of small screwdrivers, together with a T8 Torx screwdriver and a T6 Torx screwdriver. Moreover, a spudger or plastic opening instrument will likely be useful for separating parts with out inflicting scratches or injury. After you have gathered your instruments, discover a clear and well-lit workspace to attenuate the chance of shedding small components. Begin by eradicating the battery cowl from the again of the controller and setting it apart. Subsequent, use the T8 Torx screwdriver to take away the 4 screws securing the back and front covers of the controller.
Rigorously separate the back and front covers of the controller, revealing the interior parts. Find the rumble motors, that are hooked up to the again cowl, and gently disconnect them from the motherboard. Subsequent, disconnect the battery connector by fastidiously urgent on the plastic tab and pulling it away from the motherboard. With the battery disconnected, you’ll be able to take away the motherboard from the again cowl. This offers you entry to the buttons, triggers, and different parts of the controller. Proceed with warning when dealing with these parts, as they’re delicate and simply broken if not dealt with correctly.
Find out how to Disassemble Xbox One Controller
Disassembling an Xbox One controller is a comparatively easy course of that may be accomplished in a couple of minutes with the best instruments. By following these steps, you’ll be able to simply entry the interior parts of your controller and carry out repairs or modifications as wanted.
- Take away the battery cowl by sliding it down and off the again of the controller.
- Take away the 2 AA batteries from the controller.
- Find the six screws on the again of the controller and take away them utilizing a T8 screwdriver.
- Gently pry the 2 halves of the controller aside utilizing a plastic opening instrument or your fingers.
- Disconnect the ribbon cable connecting the 2 halves of the controller by gently pulling it aside.
- Take away the 4 screws securing the circuit board to the again of the controller and take away the circuit board.
- Disconnect the rumble motors from the circuit board by gently pulling them aside.
- Take away the 2 screws securing the triggers to the controller and take away the triggers.
- Take away the 2 screws securing the bumpers to the controller and take away the bumpers.
- Take away the 2 screws securing the D-pad to the controller and take away the D-pad.
- Take away the 2 screws securing the analog sticks to the controller and take away the analog sticks.
Folks Additionally Ask
How do you’re taking aside an Xbox One controller with out a screwdriver?
It’s not attainable to fully disassemble an Xbox One controller with out a screwdriver. Nonetheless, you’ll be able to take away the battery cowl and the faceplate with out utilizing a screwdriver.
How do you repair a damaged Xbox One controller?
The most typical option to repair a damaged Xbox One controller is to switch the defective part. You should purchase alternative components on-line or from an area electronics retailer.
How do you clear an Xbox One controller?
To scrub an Xbox One controller, you need to use a moist fabric or a cotton swab dipped in rubbing alcohol. You should definitely keep away from getting any liquid contained in the controller.
